Building an Arcade Joystick [29/05/2009]     So here I'm building prototype 1 for my mate's Xbox 360. I fabricated it out of MDF:        Cut of the excess....        Voila!        With the top and the button holes cut...        Time to start wiring!        Screwing the wires into the tagboard...        Lots and lots of wires...        Soldering to the ripped apart xbox 360 pcb!        Reeeeaaallly annoying!        Done! Hot glue it so it doesn't move!        Perfect! Looks shiny! It was sprayed by an auto sprayer :D        Angle 2...        Fully sick!        Hadouken!!!!1   Go back to main page...     All content on this site is copyright of me, 2006 to whenever. If you like this, email me, or head on down to www.thevulpine.com.au to listen to my band!